S2956 Hardware Installation Manual
- 17 -
1 PWR Power LED
If the switch is powered on, the indicator
is on.
2 SYS System LED
If the indicator is always on, the system
is being started.
If the LED flickers, the system works
normally.
3 LINKACT
Indicator at the top of each
port
If the LED is always on, the link on the
port is normal.
If the LED is off, the port is not
connected.
Copyright Claims
Without the written approval of the company , any person or group cannot transcribe,
copy or change partial or all contents of this manual, and must not broadcast it in any
manner.
Trademark claims
Trademarks, product names, service names and company names, which are written in
this manual but do not belong to the company, belong to their owners respectively.
Disclaimer of warranty
provides no evident or hinted guarantee towards the contents of this manual. In no
event, except for the company’s breach of law, shall the company be liable for
incidental, consequential, indirect or special damages of any kind or for loss of profits
or revenue or loss of business arising out of or relating to this manual.
Note: Customer shall not be notified of this manual’s content amendments.