3. Installation of the hose
Place the air conditioner near a window or a
balcony door. Adjust the length of the hose (11)
to reach the window/balcony door. Open the
window/balcony door and put the hose out.
If you want to use the window mount (15), pull it
out along the entire length/height of the window
and fasten it with a bolt or screw and slide the
window onto the mount. Now insert the adapter
into the opening.
ATTENTION!!
Observe the following
instructions for both
installation methods:
The air hose must be as short and as little curved as
possible to make sure the air can flow freely.
The air conditioning unit should be set up on level ground to
minimise noise and vibration. Place the device on a level
surface stable enough to support the device.
The device must be placed in the proximity of a properly
grounded outlet. Never block the air inlet and outlet
openings on the device.
The air hose is precisely tailored to this device. Do not
extend it or replace it with another hose. Non-compliance
can lead to damages to the device.
We recommand a SHE Hot-Air Stop for installation on
windows, balcony doors or sliding doors:
They offer the following advantages:
Energy saving all the warm our is blown out
Easy and quick installation
Durable, water-repellent material
Opening and closing with the HOT AIR STOP
is still possible
Washable
Available at your air conditioner provider.
To Next Page
Loading...
