20
21
OIL SPECIFICATION TABLE
FILLING FUEL
TURN ON THE FUEL VALVE LEVER
CLOSE THE CHOKE VALVE
START THE GENERATOR
Unscrew the fuel cap and fill the tank with unleaded gasoline. Ensure the
gas has an octane rating of at least 84. The fuel meter by the cap will
show how full the tank is. Do not overfill the gas tank, as there must be
room for fuel expansion during operation.
Turn the fuel valve lever to ON and let the fuel flow into the carburetor.
When cold-starting the unit, move the choke lever to the fully closed
position. Once the unit is up and running, move the lever to the half-open
position. Do not use the choke valve to power the unit down as this can
damage your engine permanently.
Push the power switch to the “ON” position to start the generator. To
extend the life of your battery, do not hold the switch down for more than
3 seconds. If you do not wish to use the battery, the unit can also be
started via the recoil cord.
WARNING
When the rated current from one socket output is more than the
socket’s nominal rated current, you should simultaneously use two or
more sockets for power output.
OPERATION OPERATION
To Next Page
Loading...
