28
29
CLEAN AIR CLEANER
CLEAN THE FUEL VALVE LEVER SEDIMENT CUP
CLEAN THE SPARK PLUG
1) Remove the air filter cover.
2) Inspect the air cleaner element and ensure that it is clean.
3) If the foam cleaner element is dirty, spray some household cleaning
agent onto a cleaning pad. Scrub the filter lightly until clean and
reinstall it. If the filter is damaged or does not come clean, it needs to
be replaced.
1) Remove the spark plug cap.
2) Clean the spark plug base.
3) Remove the spark plug with the spark plug socket spanner.
4) Inspect the spark plug insulator for damage. If it is damaged, it needs
to be replaced.
5) Measure the spark plug gap with a gap gauge. Twist the side
electrode to adjust the gap. The gap should be kept between 0 70
and 0 80mm.
6) Inspect if the washer of the spark plug is in good condition.
7) Reinstall the spark plug and tighten it with the spark plug socket
spanner. Press down on the spark plug washer and then reinstall the
spark plug cap.
Recommended spark plug models: F7RTC and F7TC
REPLACE ENGINE OIL
Place an oil pan beneath the unit and remove the oil draining bolt. Drain
the used oil. Reinstall the oil draining bolt and twist off the oil dipstick.
Fill the engine with fresh oil using a funnel to avoid spillage. Use the oil
dipstick to gauge the level, filling between the MIN and MAX lines.
MAINTENANCE MAINTENANCE
To Next Page
Loading...
