22
23
START THE GENERATOR (RECOIL START) CONNECT TO LOAD
Stopping the Generator
DISCONNECT LOAD
TURN OFF THE ENGINE SWITCH
OPEN THE CHOKE VALVE
Pull the wire gently until you feel resistance. Once resistance is felt, pull the
recoil starter briskly. You may need to do this twice in quick succession. Do
not let the cord or starter grip snap back against the engine. If the engine
does not start, ensure the choke valve is fully closed.
Comnnect electric equipment and turn the circuit breaker to ON. Do not
connect more than one load at a time. Connect each one-by-one instead.
The total power of the loads should not exceed the rated power of the
generator.
Disconnect the electric equipment from the control panel of the
generator.
After 30 seconds of running with no load, turn the power switch to the off
position. The unit will shut down shortly afterwards.
After starting, let the unit run without load for 5 seconds and then turn the
choke valve to the on position.
WARNING
The recoil cord may rapidly retract if pulled incorrectly. This can result
in injury or damage to the machine.
OPERATION OPERATION
To Next Page
Loading...
