BE HK070F - User Manual

Other manuals for BE HK070F

User's Manual & Operating Instructions18 pages

Questions and Answers

C
Cheryl ChapmanAug 11, 2025
What to do if my BE HK070F Heater fires, but shuts off quickly and shows “E1”?
- A
  April RobinsonAug 11, 2025
  If your BE Heater fires but then shuts off and displays “E1”, several issues could be the cause: * Incorrect pump pressure: Adjust the pump pressure. * Dirty filters: Clean or replace the air and fuel filters. * Dirty nozzle: Clean or replace the nozzle. * Dirty or defective photocell: Clean, replace, or adjust the photocell position. If the photocell is defective, replace it. * Wiring: Check the wiring connections between the Main PCB and the photocell.
A
aaron20Aug 16, 2025
What to do if my BE Heater will not operate and shows error code E1?
- R
  Ronald HortonAug 16, 2025
  If your BE Heater isn't operating and displays error code “E1”, consider these potential causes: * Fuel: Ensure the fuel tank has fresh kerosene. * Pump pressure: Adjust the pump pressure. * Spark plug: Clean or replace the spark plug. * Fuel filter or nozzle: Clean or replace these components. * Fuel contamination: Rinse the fuel tank with clean kerosene. * Electrical connections: Inspect the electrical connections between the transformer and circuit board and re-attach the igniter wire to the spark plug, if it is not connected. * Igniter: Replace the igniter if it is defective.
K
Kristi SparksAug 22, 2025
What to do if my BE HK070F fan is not working?
- R
  Robert HerringAug 22, 2025
  If the fan on your BE Heater isn't working, consider the following: * Thermostat setting: Increase the thermostat setting. * Electrical connections: Check the electrical connections between the Main PCB and the motor. Consult the wiring diagrams for guidance.
F
Felicia JohnsonAug 29, 2025
How to fix a BE HK070F Heater that does not turn on?
- J
  James GriffithAug 29, 2025
  If your BE Heater isn't turning on, try the following: * Overheated sensor: Turn the power off and let the heater cool for 10 minutes, then turn it back on. * Power supply: Check the power cord and extension cord to ensure they are properly connected, and test the power supply. * Fuse: Check and replace the fuse if necessary. * Temperature Limit Sensor: Inspect the electrical connection between the Temperature Limit Sensor and Circuit Board. See Wiring Diagrams.
S
Samuel BoothSep 3, 2025
Why does my BE Heater produce excess soot?
- T
  tmosleySep 3, 2025
  Excess soot from your BE Heater could be due to: * Dirty air or fuel filters: Try cleaning or replacing them. * Poor fuel quality: Ensure the fuel is not contaminated or old. * Incorrect pressure: Make sure that you are using the proper pressure.