BE HK070F - Pre-Operation; Unpacking HK070 F; Assembly HK070 F

16
16
Pre-Operation
UNPACKING HK070f
ASSEMBly HK070f
1. Remove heater from carton.
2. Remove all protective material which may have been applied to the
heater for shipment.
3. Check the heater for possible shipping damage. If any damage is
found immediately contact the manufacturer.
NOTE: Save the box and packaging materials for future storage.
1. Align the holes in the upper housing with the 2 holes in the handle as
shown.
2. Insert and tighten screws securely with screw driver.
pre-operation
PRE-OPERATION
Pre-Operation
UNPACKING HK070F
ASSEMBLY HK070F
1. Remove heater from carton.
2. Remove all protective material which may have been applied to the
heater for shipment.
3. Check the heater for possible shipping damage. If any damage is
found immediately contact the manufacturer.
NOTE: Save the box and packaging materials for future storage.
1. Align the holes in the upper housing with the 2 holes in the handle as
shown.
2. Insert and tighten screws securely with screw driver.