12 13
• This system applies detergent under
low pressure. The cleaning power
of the detergents is enhanced when
applied with low pressure and
enough time is given to break down
dirt and grime. The combination of
low pressure and chemical action
is very eective and can be better
than scrubbing if applied properly.
ALWAYS spray detergent on a dry
surface. DO NOT pre-soak area.
Wetting the surface first dilutes the
detergent and reduces its cleaning
ability. DO NOT allow detergent to
dry on surface. On vertical surfaces
being cleaned, apply detergent to
lower surfaces and work your way up
to prevent detergent from causing
streaks in the dirt and grime. Rinse
detergent by pressure washing from
bottom up for same reason.
• If a stain is particularly tough, it may
be necessary to reapply the detergent
and use a bristled brush to scrub the
stain. Subsequent power washing
after brushing should successfully
complete your cleaning job.
Cleaning Garden Hose Adapter
• The screens inside the adapter should
be cleaned periodically. Rinse it with
clean water, and then place it back in
the adapter.
Cleaning Nozzles
• A clogged or partially clogged nozzle
can cause significant reduction of water
pressure coming out of the nozzle
and/or cause the unit to pulsate while
spraying.
• Turn o the unit.
• Turn o the water supply to the unit.
• Relieve any pressure trapped in the
hose by squeezing the trigger 2-3 times,
and then lock the spray gun by pushing
the lock button from left to right.
• Remove the lance from the extension
lance
• Take o the variable spray nozzle lance.
Rotate the nozzle to narrow the stream
setting which opens up the fan blades
• Using the nozzle tip cleaner provided
(or an unfolded paper clip), insert the
wire into the nozzle hole and move back
and forth until debris is dislodged.
• Tap quick connect end of lance on hard
surface several times
• Back flush water through the nozzles
using garden hose and highest pressure
available (either standard water nozzle
or use your thumb over the nozzle to
create water pressure for back flush).
12
CARE AND MAINTENANCE
Detergents
• Use detergents designed for power washers. These
can be purchased online at our website www.
arblueclean.com. Hardware stores or home centers
also have power washer detergents for different
cleaning projects. The cleaning solution should be
the consistency of water in order to prevent clogging
your detergent bottle and nozzle.
• This system applies detergent under low pressure.
The cleaning power of the detergents is enhanced
when applied with low pressure and enough time is
given to break down dirt and grime. The combination
of low pressure and chemical action is very effective
and can be better than scrubbing if applied properly.
ALWAYS spray detergent on a dry surface. DO NOT
pre-soak area. Wetting the surface rst dilutes
the detergent and reduces its cleaning ability. DO
NOT allow detergent to dry on surface. On vertical
surfaces being cleaned, apply detergent to lower
surfaces and work your way up to prevent detergent
from causing streaks in the dirt and grime. Rinse
detergent by pressure washing from bottom up for
same reason.
• If a stain is particularly tough, it may be necessary
to reapply the detergent and use a bristled brush to
scrub the stain. Subsequent power washing after
brushing should successfully complete your cleaning
job.
Cleaning Garden Hose Adapter
• The screens inside the adapter should be cleaned
periodically. Rinse it with clean water, and then place
it back in the adapter.
Cleaning Nozzles
• A clogged or partially clogged nozzle can cause
signicant reduction of water pressure coming out
of the nozzle and/or cause the unit to pulsate while
spraying.
• Turn off the unit.
• Turn off the water supply to the unit.
• Relieve any pressure trapped in the hose by squeezing
the trigger 2-3 times, and then lock the spray gun by
pushing the lock button from left to right.
• Remove the lance from the extension lance
• Take off the variable spray nozzle lance. Rotate the
nozzle to narrow the stream setting which opens up
the fan blades
• Using the nozzle tip cleaner provided (or an unfolded
paper clip), insert the wire into the nozzle hole and
move back and forth until debris is dislodged.
• Tap quick connect end of lance on hard surface
several times
• Back ush water through the nozzles using garden
hose and highest pressure available (either standard
water nozzle or use your thumb over the nozzle to
create water pressure for back ush).
15ANR009 AR112S_1500PSI ENG-FR-SP.indd 12 16/12/17 下午12:38
To Next Page
Loading...
