14 15
PUMP SAVER
Pump Saver is a product that
protects and prolongs the life of the
pump. This will keep the internal
parts of the pump lubricated and
protected from freezing
while being stored in ALL climates.
It also assists with protection from
internal corrosion. (16 oz. bottle, BE
part number 85.490.046)
Pump Saver Instructions
Follow the previous storage
instructions for your power washer.
To prevent staining, protect the
surface under the power washer from
any excess fluid. Wear eye protection
when using this product.
Turn unit o and disconnect the
gun before adding pump protector.
Unscrew threaded top from bottle to
remove seal and reattach threaded
top to bottle. Remove black cap from
bottle.
1) Place top of pump saver bottle
onto the garden hose adapter
previously installed to pressure
washer inlet.
2) Secure pump saver bottle by
turning in a clockwise direction.
3) Turn power on. Turn the power
washer o as soon as the Pump
Storage
• When your pressure washing session
has been completed, turn o the
power switch located on the front
of the power washer. Unplug the
power cord from the outlet. Turn o
the water supply. Pull the trigger on
the spray gun 2-3 times to drain out
the excess water and to release any
remaining water pressure. Disconnect
the garden hose adapter from the
water inlet. DO NOT allow the power
washer to run with no water flowing
through it.
• Remove detergent bottle and clean
completely. Residual chemical will
stick to the container and can cause
the detergent injector to clog and not
function properly.
• Remove high pressure hose from
spray gun.
• Remove lance from the gun. Place the
gun in the holder on the side. Lances
are placed into any of the slots in the
back of the unit. Make sure to discard
any remaining detergent from the
bottle. Flush the bottle and nozzle
head with fresh water to prevent
clogging.
• Hook the power cord around the cord
hook on the right side of the machine
when facing it.
To Next Page
Loading...
