EasyManua.ls Logo

BE P1415EN - OPERATING INSTRUCTIONS

BE P1415EN
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 11
Turn on water supply at the
faucet to completely open.
Make sure the “ON/OFF” switch is
in the “OFF” position. The power
switch has international symbols
for ‘on’ and ‘o’: On (|) O (O).
Unwind the power cord
completely and plug the GFCI
into a grounded 120 volt outlet.
Release the safety lock button
on the spray gun by pressing the
top half of the safety lock button.
While pointing the spray gun in a
safe direction, squeeze the trigger
on the spray gun until there is a
steady stream of water, letting
the water and air out of the hose.
Turn the power switch to the
“ON” (|) position. The unit will
10
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
Turn on water supply at the faucet to completely
open.
Make sure the “ON/OFF” switch is in the “OFF”
position. The power switch has international symbols
for ‘on’ and ‘off’: On (|) Off (O).
Unwind the power cord completely and plug the GFCI
into a grounded 120 volt outlet.
Release the safety lock button on the spray gun by
pressing the top half of the safety lock button. While
pointing the spray gun in a safe direction, squeeze
the trigger on the spray gun until there is a steady
stream of water, letting the water and air out of the
hose.
Turn the power switch to the “ON” (|) position. The
unit will turn on for 1 - 2 seconds and shut off. This is
a normal function of the auto start feature. Squeeze
the spray gun trigger to begin pressure washing.
Unlock
F
OFF/0
ON/I
OFF/0
ON/I
15ANR009 AR112S_1500PSI ENG-FR-SP.indd 10 16/12/17 下午12:38
turn on for 1 - 2 seconds and shut
o. This is a normal function of
the auto start feature. Squeeze
the spray gun trigger to begin
pressure washing.
Release the safety lock button on
the spray gun by pressing the top
half of the safety lock button. While
pointing the spray gun in a safe
direction, squeeze the trigger on
the spray gun until there is a steady
stream of water, letting the water
and air out of the hose.
• Release the spray gun trigger to
stop the power washer
Allow the motor to come to a
complete stop before squeezing
the trigger again.
Squeezing rapidly will cause the
auto start feature to miss an on/
o cycle that may prevent it
from turning on while squeezing
trigger after rapid squeezing. Use
slow deliberate trigger pulls to
avoid such symptoms.
Always test a small area to avoid
chance of damaging the surface.
10
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
Turn on water supply at the faucet to completely
open.
Make sure the “ON/OFF” switch is in the “OFF”
position. The power switch has international symbols
for ‘on’ and ‘off’: On (|) Off (O).
Unwind the power cord completely and plug the GFCI
into a grounded 120 volt outlet.
Release the safety lock button on the spray gun by
pressing the top half of the safety lock button. While
pointing the spray gun in a safe direction, squeeze
the trigger on the spray gun until there is a steady
stream of water, letting the water and air out of the
hose.
Turn the power switch to the “ON” (|) position. The
unit will turn on for 1 - 2 seconds and shut off. This is
a normal function of the auto start feature. Squeeze
the spray gun trigger to begin pressure washing.
Unlock
F
OFF/0
ON/I
OFF/0
ON/I
15ANR009 AR112S_1500PSI ENG-FR-SP.indd 10 16/12/17 下午12:38
10
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
Turn on water supply at the faucet to completely
open.
Make sure the “ON/OFF” switch is in the “OFF”
position. The power switch has international symbols
for ‘on’ and ‘off’: On (|) Off (O).
Unwind the power cord completely and plug the GFCI
into a grounded 120 volt outlet.
Release the safety lock button on the spray gun by
pressing the top half of the safety lock button. While
pointing the spray gun in a safe direction, squeeze
the trigger on the spray gun until there is a steady
stream of water, letting the water and air out of the
hose.
Turn the power switch to the “ON” (|) position. The
unit will turn on for 1 - 2 seconds and shut off. This is
a normal function of the auto start feature. Squeeze
the spray gun trigger to begin pressure washing.
Unlock
F
OFF/0
ON/I
OFF/0
ON/I
15ANR009 AR112S_1500PSI ENG-FR-SP.indd 10 16/12/17 下午12:38
to your power washer.
Note: Flush out garden hose before connecting to garden hose adapter.
OPERATING INSTRUCTIONS

Related product manuals