31
TV Settings
TV Provider Changes &
Channel Auto Scan After Initial Setup
To enter the Channel Menu:
•
Press the MENU button
• Using the arrow buttons; scroll to highlight Channel
•
Press the down arrow buttons to highlight Air / Cable
Select Cable if you subscribe to a pay television service without a set top box.
•
Press the arrow buttons to highlight Cable.
•
NOTE: Channel Auto Scan may take several minutes to complete.
Cable Mode
Air Mode
Select Air when TV is connected to an indoor / outdoor antenna.
•
Press the arrow button to highlight Air.
•
NOTE: Channel Auto Scan may take several minutes to complete.
satellite set top box to one of the available inputs on the TV for viewing.
Note: For Cable or Satellite users with a set-top box, there is no need to run Channel Auto Scan. Connect your cable
To make changes your TV provider or re-scan for available broadcast channels in your area, select the Channel Menu.
Press the arrow button to highlight Auto Scan and press ENTER. Press the arrow button to highlight YES
and press ENTER to begin Auto Scan.
Press the arrow button to highlight Auto Scan and press ENTER. Press the arrow button to highlight YES
and press ENTER to begin Auto Scan.
Are you sure to Auto
Scan?
No
Yes
Total Found : 0
Analog : 0
Digital : 0
RF CH : 2
Next
Channel List
Show/Hide
Channel Number
Channel Label
5-2
KSTP-SD
Are you sure to Auto
Scan?
No
Yes
Total Found : 0
Analog : 0
Digital : 0
RF CH : 2
Favorite
Auto Scan
Next
Channel List
Show/Hide
Channel Number
Channel Label
5-2
KSTP-SD
Favorite
Auto Scan
To Next Page
Loading...