What to do if BEA Scanner field is touching floor/wall/door/object/person?
If the BEA Scanner field is touching the floor, wall, door, object, or person, it can lead to unwanted detection. Here's what you should do: * Activate the 3 red beams and check the sensor's position. Adjust the hex screws if it's not correct. * Verify the field size. * Launch a learn.
What to do if BEA LZR-I30 Scanner remote control is not pointed correctly?
If the remote control isn't working, make sure to point it towards the BEA Scanner with a slight angle. Avoid pointing it directly at a right angle in front of the sensor.
What to do if my BEA LZR-I30 Scanner has no power?
If your BEA Scanner has no power, check the cable and connection to ensure they are properly connected.
What to do if BEA LZR-I30 Scanner is masked?
If the BEA Scanner is masked, verify and clean the front screens with a damp cloth.
What to do if BEA LZR-I30 Scanner has an internal error?
If your BEA Scanner shows an internal error, wait a few seconds. If the LED remains ON, reset the power supply. If the LED turns on again, replace the sensor.
What to do if BEA LZR-I30 remote control batteries are not installed properly or are dead?
If the remote control isn't working, check the battery orientation or replace the batteries in your BEA Scanner remote.
What to do if BEA LZR-I30 Scanner test input is not connected?
If the test input of your BEA Scanner is not connected, check the wiring. Ensure that the blue and blue/white cable are connected to the test input or the power supply.
What to do if someone or something is in the BEA LZR-I30 Scanner detection field?
If the BEA Scanner detects someone or something in the detection field, step out of the field and/or remove any objects from the field.
What to do if BEA LZR-I30 Scanner access code needs entered or an incorrect code was used?
If the BEA Scanner requires an access code or an incorrect code was used, cut and restore the power supply. No code is required to unlock during the first minute after powering.
Why is my BEA LZR-I30 Scanner detection field too small or deactivated?
If the BEA Scanner detection field is too small or deactivated, check the size of the fields and launch a learn.
General| Type | Laser Scanner |
|---|---|
| IP Rating | IP65 |
| Scanning Technology | Laser Time-of-Flight |
| Protection Rating | IP65 |
| Output | Relay |
| Power Supply | 10 - 30 VDC |
| Detection Zones | Configurable |
To Next Page
