What to do if no background (reference point) is found on BEA LZR-I30 Scanner?
If no background reference point is found by the BEA Scanner, follow these steps: * Check the position of the sensor. * Check the mounting side setting. If no reference point is found, set the mounting side to value 3 to 5. * Launch a new learn.
What to do if BEA LZR-I30 object size is too small?
If the object size is too small for the BEA Scanner to detect, decrease the minimum object size.
What to do if BEA Scanner power supply voltage exceeds acceptable limits?
If the BEA Scanner power supply voltage exceeds acceptable limits, check the power supply voltage.
What to do if BEA Scanner exceeds temperature limits?
If the BEA Scanner exceeds temperature limits, verify the temperature of the environment and protect the sensor from sunlight using a cover, if necessary.
What to do if BEA Scanner reflective object is close to the sensor?
If a reflective object is too close to the BEA Scanner, avoid highly reflective material in proximity to the sensor.
General| Type | Laser Scanner |
|---|---|
| IP Rating | IP65 |
| Scanning Technology | Laser Time-of-Flight |
| Protection Rating | IP65 |
| Output | Relay |
| Power Supply | 10 - 30 VDC |
| Detection Zones | Configurable |
To Next Page
