Beacon 800 - User Manual

Questions and Answers

C
Carmen MartinezJul 27, 2025
How to troubleshoot a Beacon 800 that has no power?
- E
  emily01Jul 27, 2025
  If your Beacon Monitor isn't powering on, there are several potential causes: * The power wiring might be disconnected or improperly connected. Ensure the wiring to the power source is correctly connected and secure. * The AC or DC fuse could be blown. Check the continuity of the appropriate fuse (AC or DC). * The display cable may be disconnected or misconnected. Make sure the display cable is properly connected.
V
vliAug 2, 2025
Why does my Beacon 800 have frequent false alarms?
- N
  nharmonAug 2, 2025
  Frequent or suspect alarms on your Beacon Monitor can stem from a few issues: * False readings due to RFI or EMI. Ensure the transmitter wiring is properly shielded. * Disconnected, misconnected, or intermittent transmitter wiring. Verify the transmitter wiring is correctly connected and secure. * Wiring issues. Make sure that power and transmitter wiring is routed through separate conduit hubs on the bottom of the Beacon 800 housing. * Alarm sensitivity. Try increasing the alarm on delay setting in the Configuration menu.
D
doylebrandiAug 8, 2025
What to do if my Beacon 800 Monitor display is flickering?
- W
  Walter GonzalezAug 8, 2025
  A flickering display on your Beacon Monitor could be due to: * False readings caused by RFI or EMI. Verify that the transmitter wiring is properly shielded. * A low noise filter setting. Increase the noise filter setting in the Configuration menu. * A low zero suppression setting. Increase the zero suppression setting in the Configuration menu. * A malfunctioning display screen.
A
amanda88Aug 14, 2025
How to fix a Beacon Monitor buzzer that is not working?
- J
  Joshua MirandaAug 14, 2025
  If the buzzer on your Beacon Monitor isn't working, it could be due to: * Disconnected or misconnected wiring. Verify that the wiring to the BUZ- and BUZ+ terminals of the controller terminal strip is correct and secure. * A malfunctioning buzzer.
J
Jennifer BennettAug 20, 2025
Why won't the reset switch work on my Beacon 800?
- J
  Julie BoothAug 21, 2025
  If the reset switch on your Beacon Monitor isn't working, consider these possibilities: * The reset switch wiring might be disconnected or misconnected. Verify that the wiring to the RESET (2) terminals of the controller terminal strip is correct and secure. * The reset switch itself may be malfunctioning.