Beacon S242P - Osd Menu Introduction

S242P User Manual
10
4.1 OSD MENU INTRODUCTION
Main Menu Sub Menu Reference
Input
Main Input VGA/DVI /CVBS /S-VIDEO/YPbPr/ RGB/SDI
PIP Mode Large pip, Side-by-side， Off
Image
Brightness Brightness adjust
Contrast
Contrast adjust
Sharpness
Sharpness adjust
Aspect Ratio
5:4/ 4:3/ Full/ Full Aspect/ Native/ User
Mode Select
Overlapping mode selection（According to different input
signal to select different suitable overlapping mode.
Setup
Color Temp 5500K/6500K/7500K/8500K/9300K/10000K/User
Gamma DICOM/ 2.4/2.3/2.2/ 2.1/ 2.0/ 1.8
RGB/ YPbPr
RGB/ YPbPr SEL
RGB/YPbPr signal select
OSD Position
Center/Top Left/Top Right
Bottom Left/Bottom Right
OSD Language English /Chinese
Auto Scan Input On off
Factory Reset Restore the factory default parameters
VGA
Auto Adjust
Automatic adjust displays，Detailed to see 5.2-5.4.
H-position
V-position
Clock
Phase
Lock Key Lock Lock or unlock the touch-key shortcut functions
Status
FW version Software version information
Main Input The input information of main signal source
Main Format The input signal format of main singnal source