BEAMEX TC303 - User Manual

Service manual for
TEMPERATURE CALIBRATOR
TC305/TC303
Dear user,
We have made every effort to ensure the accuracy of the
contents of this manual. Should any errors be detected, we
would greatly appreciate to receive suggestions to improve the
quality of the contents of this manual.
The above not withstanding, we can assume no responsibility
for any errors in this manual or their eventual consequences.
We reserve rights to make modifications to this manual without
any further notice.
For more detailed technical data about the Service manual for
TC305/TC303, please contact the manufacturer.
© Copyright 1997
OY BEAMEX AB
P.O. Box 5
68601 Pietarsaari
FINLAND
Tel +358 - 6 - 7840111
Fax +358 - 6 - 7840404
E-mail: sales@beamex.com
Internet: http://www.beamex.com
8830100 / SETC305 / 912417

Summary

Service and Troubleshooting

Warning Messages

Lists and explains warning messages displayed by the calibrator during operation.

Hardware Error Codes

Identifies and explains hardware error codes and their potential causes for diagnostics.

Disassembly and Reassembly Guide

Battery Pack Replacement

Step-by-step instructions for replacing the calibrator's battery pack.

Front Assembly Troubleshooting

Focuses on troubleshooting issues with the display, keypad, and battery pack.

Power Supply Board Diagnostics

Instructions for checking and troubleshooting the power supply board and its voltage outputs.

Analog I;O Assembly Troubleshooting

Guidance on diagnosing problems with the analog I/O assembly and serial number configuration.

Processor Board Faults

Describes common symptoms and troubleshooting for processor board failures.

Calibration Procedures

Required Calibration Equipment

Calibrating Section B Measurements

Step-by-step process for calibrating the B-section's measurement functions.

Calibrating Section A Measurements

Step-by-step process for calibrating the A-section's measurement functions.

Calibrating Resistance Simulation

Guide on how to calibrate the resistance simulation capabilities of the device.

Calibrating Reference Junction Compensation

Instructions for calibrating the internal reference junction compensation feature.

Serial Communication Interface

Interface Basics

Device Configuration Commands

Calibration and Service Commands

Commands used to access calibration modes and service functions.

Special Communication Commands

BEAMEX TC303 Specifications

General

Brand	BEAMEX
Model	TC303
Category	Test Equipment
Language	English