Need help?Do you have a question about the Bearifi EDGE Mesh and is the answer not in the manual?
General| Wi-Fi Standard | 802.11ac |
|---|---|
| Ports | 1 x Gigabit Ethernet |
| Mesh Technology | Yes |
| MU-MIMO | Yes |
| Beamforming | Yes |
| Frequency Bands | 2.4 GHz and 5 GHz |
| Maximum Speed | 1200 Mbps |
| Coverage Area | Up to 1500 sq ft |
| Security | WPA2 |
Connect to Bearifi Wi-Fi and log in to the administrator IP address.
Access the Wi-Fi configuration section through the menu.
Update the 2.4G SSID and Wi-Fi password in the provided fields.
Apply the new Wi-Fi settings by saving the configuration.
Connect to Bearifi Wi-Fi and log in to the administrator IP address.
Access the TouchLink configuration section via the Wi-Fi menu.
Turn on TouchLink and set connection time for guest access.
Apply the TouchLink configuration by saving the changes.
Connect to Bearifi Wi-Fi and log in to the administrator IP address.
Access the Wi-Fi configuration section through the menu.
Toggle the Smart Connect feature off for separate 2.4/5 GHz bands.
Apply the Smart Connect configuration changes by saving.
Navigate to the Wi-Fi menu and select Mesh Network.
Assign a name and enter the MAC address for the new satellite.
Save the satellite settings and allow the router to reboot.
Navigate to the main Options menu within the administrator interface.
Select the LED Control option from the menu.
Turn LED lights ON or OFF for the Main AP and Satellites.
Apply the LED control settings by saving the changes.
Press and hold the reset button on the Bearifi Edge Mesh AP for 10 seconds.
Allow the AP to restart and reconnect your device after the reset.
Address satellite issues post-reset by following specific re-addition steps.
To Next Page