6. Factory Reset Bearifi Edge Mesh
Reset needs to be done only on the Bearifi Edge Mesh AP (not the Satellites).
1. Using a pen or fine tip object, press and hold in the reset button underneath the power switch for 10 seconds until a green light comes on over each LAN
port. Then release the reset button.
2. Bearifi Edge Mesh AP will now restart. This takes about 60 seconds.
3. While waiting, turn off your computer's internal Wi-Fi card and turn it back on, or restart your computer or device
4. After 60 seconds, scan for the “Bearifi” WiFi network on your computer or device.
The Bearifi Edge Mesh AP will now be just like new with no password protection and is all ready for setup.
Satellite units generally do not need factory reset as they will be reset by the master process above, however if a Satellite is not still not working, follow these
same steps above on the Satellite to reset it.
If your Satellite is no longer recognized by your Bearifi Edge Mesh AP after factory reset (flashes red for more than 180 seconds after power up), you may
need to add your Satellite back to your Bearifi Edge Mesh AP device. First try powering the Satellite off and back on, and waiting three minutes. Then refer to
section 4 of this manual, “Adding a Satellite” to add the Satellite again.
Factory Reset Steps
To Previous Page
Loading...