1. Connect your PC or device to
the ‘Bearifi’ Wi-Fi signal
and log in at the 192.168.10.1 IP
address to access the
Bearifi Edge administrator area.
2. Click the WiFi menu option
3. Click TouchLink
5. Click save. Then Allow router to reboot.
TouchLink is a patented feature which
allows you to broadcast a separate guest
network that is fully secure, but does not
need a password.
Instead, when TouchLink is enabled in
settings, you or your guest can press the
top of the Bearifi Edge Mesh AP unit and
the light will flash blue for 60 seconds.
During this period, your guest can join
the BearifiTouch network without needing
a password. When the light stops
flashing, this network becomes fully
secure and cannot be accessed. You can
change the flashing time in the settings if
you wish to allow a connection for a
shorter period time, such as only 20
seconds after the top is pressed.
4. Turn TouchLink ON
2. TouchLink Setup
To Next Page
Loading...