Bebcare Motion - Trouble Shooting Guide

22
Solution
- Adjust mic sensitivity higher using
setting menu in PU .
- Check connection
- Adjust mic sensitivity or movement
sensitivity lower
- Set to auto off or VOX on
- Switch on camera or check AC
adaptor
- Move camera and PU closer to
each other
- Perform paring again.
- Move parent unit closer to camera
- Increase light intensity of baby’s
room or adjust night vision
changeover in setting menu of PU
- Move the source of interference
away from baby monitor
- Recharge battery using AC
adaptor.
- Set to auto off or VOX on mode
- Replace with new battery.
- Press volume up button to resume
output from speaker.
- Re-locate camera and PU
- Press OK button to switch
listening to your preferred camera
Possible Causes
- Camera mic sensitivity is too low
- AC adapter improperly connected
in camera
- Mic sensitivity or movement
sensitivity is too high
- Screen On mode is activated
without auto off
- Camera is switched off or
No power supply
- Distance between camera and
PU exceed operating range
- Pairing is lost or not performed
properly
- Reaches the operating range limit
- Light intensity too low in baby’s
room, camera operates under
night vision mode using infrared
LED as source of illumination.
- Interference from other electronic
devices such as WiFi router
- Battery has run down.
- Screen on mode is activated
without auto off
- Rechargeable battery is
damaged.
- Speaker is muted.
-Too many partitions between
camera and PU
- PU is listening to other camera
Problem
No audio or video
signal is transmitted
Always transmission
Out-of-range alarm
always on
Image on screen
not smooth or become
still or become black
white
Frequently showing
low battery in PU
Speaker has no
sound in PU
Too short communication
range
No audio under split
screen mode
TROUBLE SHOOTING GUIDE