8
Parent unit
1. Switch on PU by setting the power ON/OFF/vibration switch to either I or
position. (In position, the unit will start to vibrate once there is sound from baby.
Such vibration is to alert the parents in case they are not watching the screen). At
the same time, the power on indicator 18 show steady green. If this indicator starts
flashing green, the Li batteries have run down and need to be recharged using the
supplied 5V AC adapter.
2. The image captured by the camera lens should be shown on screen 20 while the
sound picked up by microphone 5 should be heard from speaker 24 . In case the
screen 20 shows the text “ No signal or Out of Range “, it means the units are not
properly paired (refer to PAIRING SECTION).
3. Adjust the volume of speaker 24 to obtain a comfortable listening level using the
qqqq volume up/down button 23, a corresponding bar graph will be shown on
screen 20. In case the parents prefer to keep the environment quiet, just press the
volume down button until the icon shows up and the speaker 24 become
muted. To resume the speaker sound output, press the volume up button again.
4. Use 14, 15, 16, 17 button to control the pan/tilt of camera lens. Note only
one button should be pressed each time.
5. The parent can talk back to baby anytime they prefer by using the talk back function :
a. Press and hold the talk back button 19 , will show up on screen 20.
b. Speak towards the microphone 13 .
c. Your voice will be heard from speaker 10 in camera .
d. Adjust the volume of speaker using the Setting menu.
e. Release the talk back button 19 to listen to baby.
To Next Page
Loading...
