Drive Control
DC RS alpha
Issue 09/99
24
Important notes and interesting information
Dear customer,
with the drive controller DC RS
alpha you have purchased a technically high-
quality product. For this device only high-quality components are used which
meet the requirements of the VDE-regulations as well as the DIN and Europe
norms.
All information in this instruction manual are collected and checked to the best of
one’s knowledge and belief. Prior to installing and starting up the device please
read carefully this instruction manual.
bebro electronic GmbH does not take any liability to the use and to damages,
which are the results of wrong operation and handling, misuse, unauthorized
technical modifications or due to repairs by unauthorized personnel.
If you have any questions please contact your distributor or bebro electronic
GmbH.
Safety notes
Please read carefully the following safety notes and consider them accordingly.
These rules are the assumptions for a safe usage of the electronic.
WARNING
• Only connect and assemble electrical equipment when the
device is switched-off and no voltage is applied. Danger!
• Only specially trained service personal is allowed to perform
connecting and assembling procedures while taking into
account the corresponding VDE-regulations.
CAUTION
• The device is determined for the installation in a machine.
Start-up of the device is not allowed unless it is conformed
that the complete installation corresponds to the applicable
VDE-regulations.
• Connected machines and installations must have separate
monitoring and safety equipment independent of the smart
drive controller DC RS
alpha.
• It is only allowed to operate the drive controller DC RS
alpha at safety low voltage and it is only designed for the
usage with DC-motors.
To Next Page
Loading...