Drive Control
DC RS alpha
Issue 09/99
32
1.8 Technical data
General and mechanical data
Housing without
Dimensions circuit board approx. 70 x 100 x 30 mm
DIN rail adapter approx. 77 x 110 x 35 mm
Weight circuit board approx. 100 g
DIN rail adapter approx. 60 g
Installation Installation in a closed control cabinet or similar
metal housing, enclosure rating IP4x.
Mounting vertically. Installation on spacing bolts
using 4 mounting holes or with DIN rail adapter on
DIN rail.
Adequate ventilation has to be provided (free
convection).
The wiring has to be carried out in accordance with
EMC.
Ambient temperatures Operation 0 up to 50°C
Storage -25 up to 85°C
Humidity 95 % max. relative humidity, non-condensing
Allowed pollution severity 2
EMC meets the requirements of EN 50081-2 and
EN 50082-2
Safety class 3
Enclosure rating open unit, IP00 acc. to IEC 529 / EN 60529 / DIN
VDE 0470, part 1 (enclosure rating through
housing)
Isolation Operation at protective low voltage (SELV)
Contact voltage proof not necessary
Isolation of interfaces not physically separated from supply voltage
Connectors 2 plug-in terminal strips with screw terminals
1 4-pin plug for serial interface
To Next Page
Loading...