Drive Control
DC RS alpha
Issue 09/99
39
• a switching-off is required due to overtemperature.
After a quick stop the motor starts corresponding to the ramp setting when the
signal at the release input HE3 is switched off and subsequently switched on
(removing the reclosing interlock), or when the supply voltage is switched off
and subsequently switched on.
3.9 Motor release
Input: HE3
The release enables the counter-clockwise/clockwise rotation of the motor with
the adjusted ramp and removes the lock after a quick stop or failure.
The release is "given" when the input HE3 is closed (switched to logical 1).
3.10 Application specific programming
The programming software BeCon allows you to develop your own application
specific programs. These programs can then be loaded into the drive controller
via the serial interface.
When programming any motor parameters can be set. In addition the PLC
programming allows to assign the potentiometers P1 to P3 to the motor
parameters in any way. For detailed information to programming the drive
controller using BeCon refer to the BeCon manual or the BeCon help.
If you have questions concerning the PC software BeCon please contact directly
bebro electronic. You can download a free test version of BeCon from the bebro
homepage (http://www.bebro.de).
NOTE
For connecting to a standard PC interface (RS232) the level
converter PW RS232 is required as well as a special adapter (is part
of the software package BeCon).
To Next Page
Loading...