Becker R35/8G - English; Introduction; Warranty

10
Operating Instructions
D.C. tubular drives R35/8G to R120/3G are high-quality products which boast a wide range of performance features.
• For use in roller shutters
• For use in awnings
• Easy setting of fi nal limit positions on the drive
Please adhere to these instructions when installing and setting up the system.
Table of Contents
BeckerAntriebe GmbH will be released from all warranty and product liability obligations if the customer modifi es the equip-
ment without prior approval from BeckerAntriebe GmbH or if the equipment is installed incorrectly and/or contrary to the
specifi ed installation instructions, by the customer or a third party.
Any further processing must comply with all current statutory and offi cial regulations governing manufacture and advice to
customers, especially the EMC regulations.
This product is subject to technical developments and improvements. Please refer to the current sales brochure for the pre-
cise product specifi cations.
Despite extensive tests, BeckerAntriebe GmbH cannot guarantee function of the drives in combination with controls of other
manufacturers. Please consult BeckerAntriebe GmbH before installation; we will be pleased to assist you.
Introduction
Warranty
Introduction .............................................................................................................................................................. 10
Warranty ...................................................................................................................................................................
10
Safety Information ......................................................................................................................................................11
Intended use ............................................................................................................................................................ 12
Montageanleitung ..................................................................................................................................................... 12
Setting the End Limits ................................................................................................................................................ 14
Information for the Electrician .................................................................................................................................... 15
Technical data ..........................................................................................................................................................
15
Connection example ................................................................................................................................................. 15