Need help?Do you have a question about the Beckhoff BK3110 and is the answer not in the manual?
General| Bus System | EtherCAT |
|---|---|
| Number of EtherCAT Ports | 2 |
| Number of I/O Modules Supported | 64 |
| Data Transfer Rate | 100 Mbit/s |
| Protocol | EtherCAT |
| Operating Voltage | 24 V DC (-15 %/+20 %) |
| Protection Class | IP20 |
| Storage Temperature | -25°C to +85°C |
| Relative Humidity | 95%, non-condensing |
| Vibration/Shock Resistance | acc. to EN 60068-2-6/EN 60068-2-27 |
| EMC Immunity/Emission | acc. to EN 61000-6-2/EN 61000-6-4 |
| Approvals/Markings | CE, UL, ATEX |
Guidelines for safe installation, handling, and usage of components.
Information regarding ATEX certification and special conditions.
Special conditions for using components in potentially explosive areas.
Special conditions for ET components in potentially explosive areas.
Settings configurable via UserPrmData for Bus Coupler functions.
General information on configuring Bus Couplers and terminals.
How CfgData is generated from DP configuration tools.
Steps for adding DP modules for Bus Coupler functions in configuration.
Adding complex terminal modules to the DP configuration.
Rules for configuring digital terminals based on input/output bit counts.
Steps for configuring Bus Couplers with Siemens S7 controllers.
How cyclic data is exchanged between master and slave.
How process data is mapped into the Bus Coupler's memory.
Configuration and timing of the K-bus cycle relative to the DP cycle.
Explanation of acyclic data transfer using DPV1.
Information on DP standard and device-specific diagnostic data.
Structure and interpretation of DP diagnostic data.
Common errors encountered during the DP start-up phase.
Using multi-configuration mode for flexible terminal setups.
To Next Page
