Appendix
CX8030 / CX8031 95Version: 1.6
• Wait until copying has finished, then remove the USB cable
• Switch DIP switch 1 to OFF
• Switch off the CX80xx
• Switch on the CX80xx; it may take a little longer the first time
Update the MicroSD card
A MicroSD card reader is required for this!
• Remove the MicroSD card from the switched-off CX device.
• Insert the MicroSD card into the reader
• Delete all files (we recommend that you backup all files first), no formatting
• Load the new image
• Wait until copying has finished, then remove the MicroSD card
• Insert the MicroSD card into the SD slot of the switched-off CX again
• Now switch on the CX again; it may take a little longer the first time
To Next Page