25 EN
Before Initial Use
NOTICES
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and soften the
adjustable feet of the device. If necessary, place a suitable pad below the adjustable feet.
• There may still be some production residues on the device. To avoid harmful effects
to your health, clean the device before you fi rst use it (see the "Cleaning and Care"
chapter).
1. Remove all packaging materials and any possible protective fi lms used for protection during
transportation. Never remove the rating plate and any possible warnings!
2. Wipe down the device with a clean, damp cloth. Rinse the glass jug (6), the thermal jug,
the fi lter insert and the permanent fi lter as well as the measuring spoon with a little mild
detergent and clear water.
3. Set up the device in a suitable location, following the safety instructions and the notes pro-
vided at the beginning of this chapter.
4. Pull the mains cable out of the cable compartment and plug it into a properly installed,
easily accessible plug socket.
5. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run with coffee
beans to remove any possible production residues in the water system and in the grinder
shaft. To do this, follow the instructions in the “Handling and Operation” and “Preparation”
chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device
defect.
6. Perform this process twice. Caution! Do not drink this coffee!
7. Clean the device and accessories (see the “Cleaning and Care” chapter).
To Next Page
Loading...
