EasyManua.ls Logo

Beem 351202 - Making Coffee with Coffee Beans

Beem 351202
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 28
Drip Stop
The device has a drip stop which prevents water from dripping out of the lter when the jug
has been removed from the device.
When the device is in operation, the lter compartment (5) must be closed and a jug with a lid
placed on it must be placed beneath the lter compartment. The lid of the jug pushes the drip
stop upwards and the coffee can ow from the lter through the lid into the jug.
During the brewing process, the jug must not be removed from the device for longer
than 30 seconds as otherwise the lter could over ow.
Preparation
NOTICES
Do not operate the device without water or with less water than is required to reach
the 2 Cups mark. If this does happen, the device switches off automatically. In this case,
allow the device to cool down before water is poured in and the device is used again.
Never use the device without a suitable jug below the coffee outlet.
Making Coffee with Coffee Beans
1. Fill the water tank (11) (see the “Handling and Operation” chapter –Filling the Water
Tank ).
2. Fill the coffee bean compartment (2) (see the “Handling and Operation” chapter – “Adding
Coffee Beans”).
3. Set the grinding neness you want (see the “Handling and Operation” chapter – “Setting
the Grinding Fineness).
4. Open the lter compartment (5).
5. Insert the permanent lter (see the
Handling and Operation” chapter –
Inserting the
Filter”).
6. Close the lter compartment.
7. Set the desired number of cups with the button
(25)
(see the “Handling and Opera-
tion” chapter – “Setting the Number of Cups”).
8. Set the desired coffee strength with the button
(19)
(see the “Handling and Operation”
chapter – “Setting the Coffee Strength”).
9. Press the button
(18) to switch on the grinder and start the brewing process. The
operating lamp ashes. Freshly ground coffee is transported through the grinder shaft into
the lter and then hot water is poured over it to brew it.
If the brewing process is to be aborted prematurely, press the
button. The operating
lamp goes out and the device is switched off.

Related product manuals