i. Basic – Basic gimbal stabilization settings. Adjusting these settings is usually
adequate to achieve good camera stabilization.
ii. Advanced – More precise tuning options.
iii. RC Settings – Settings to control the gimbal roll/pitch/yaw orientation with RC
inputs.
iv. Service – Specify the behavior of the MENU button (located on the controller board
or mounted externally) and tune the battery monitoring service.
v. Follow Mode – Settings related to this special mode of camera control.
vi. Realtime Data – Realtime sensor data monitoring. This screen is helpful in tuning
your gimbal performance.
vii. Firmware Upgrade – Firmware and SimpleBGC GUI software versions and update
options.
4. Control Panel – Graphic visualization of gimbal orientation angles for all three axes.
• Black arrows display the angles.
• Blue arrows are a 10x time magnification to provide higher precision.
• Red marks show target angles that the gimbal should hold.
• Thin blue lines show the peak deflection from the central, neutral point.
• Blue digits show peak deflection amplitude, which provides an estimation of
stabilization quality.
• Vertical red bars to the right of the scales show actual power level from 0 to 100%.
5. READ, WRITE, USE DEFAULTS buttons are used to transfer settings to/from the
controller board.
6. MOTORS ON/OFF button – Toggle motor state.
7. Tips, status or error messages (in red color) are displayed at the bottom of the screen.
Overall cycle time and I²C error count is also displayed.
8. Battery voltage indicator with warning sector.!