Inspect and grease all fittings on frame (see fig. 5).
Install PTO protection guard over gearbox output shaft using the supplied hose clamp
(see fig. 6).
Install wing hooks using the bolts M16x130 the elastic stop nuts M16 and spring to
install the hook. Use two roll pins Ø6x32 to assemble the locking pin for the hook to
latch on to (see fig. 7).
OPERATION 14 BEFCO
R
OTARY TEDDERS OPERATOR’S MANUAL
Fig. 5 - Grease fittings.
DRO-480 only
qty. 4
DRO-480 only
qty. 4
Fig. 6 - PTO guard placement.
hose clamp
safety protection
Fig. 7 - Wing hooks.
locking pin
roll pin 6x32
bolt M16x130
bolt M10x20
To Next Page
Loading...