Bego Fornax T - Electrical Connections; 230 V Power Connection; Installation for Non-230 V Networks

14
86107 BA-en/01
English ⋅ Fornax
®
T
en
Electricity
Check if the specifications on the type plate corre-
spond to the power supply network before
connecting the device. Consult an electrician in
case of uncertainty.
The device is subject to protection class I and must
only be connected to properly grounded and
protected power sources.
Recommendation: Always operate the device in a
single power circuit (min. 16A fuse).
Installation in countries without 230 V
network
The electrical installation must only be carried out by
a qualified electrician!
Use the transformer (accessory REF 17800) for
connection.
1. Adapt the power connection of the transformer
to local circumstances.
2. Insert the Fornax
®
-power plug into the trans-
former.
The device is subject to protection class I and must
only be connected to properly grounded and
protected power sources.