English
⋅
Fornax
®
T
13
86107 BA-en/01
Installation
Installation
1. The device may only be installed on a suffi-
ciently stable surface.
2. Use two open-ended wrenches (13 and 17
mm) to turn the feet of the unit clockwise and/
or counterclockwise until the unit is properly
aligned and level. Check the alignment with
the aid of a spirit level.
3. Place the crucible stand in its intended space
below the crucible coil as protection against
hot casting beads. Please observe the follow-
ing pages for opening the cover.
The warning signs provided (symbol:
"pacemaker") are to be placed at the
entrances to the room in which the
ready-to-operate machine is located!
To Next Page
Loading...
Need help?
General
