English
⋅
Fornax
®
T
25
86107 BA-en/01
9. Visually check the melt; lower the crucible coil
if the melt appears to be ready for casting.
Push the handle located on the right exterior
side of the device backward for this purpose.
10. The spinning process will start.
The cover will be unlocked automatically when the
spinning process is completed (after approx. 35
seconds). (audible click)
The indicator lamp "Open cover" blinks.
11. Lift cover.
12. Remove the mould.
13. Repeat the steps described above, starting
with the selection of the proper crucible insert,
for additional casting processes (see 16).
14. When all casting processes are completed,
turn the unit off with the main switch located on
the right side of the unit's housing.
Burn hazard from hot parts!
Always use mould tongs to move
moulds.
To Next Page
Loading...
Need help?
General
