English
⋅
Fornax
®
T
9
86107 BA-en/01
Special safety instructions regarding this device
Danger due to electric shock
• The device is categorised under
protection class I and may only be
connected to properly earthed pow-
er sources (earth contact sockets).
Danger of deflagration
• The cooling water temperature must
never drop below 10°C (50°F). Oth-
erwise condensation water may
land on the hot moulds and vaporize
explosively.
Danger from waste gases
• Ensure there is adequate ventilation
in view of the waste gases arising
during the casting of dental alloys.
Electromagnetic radiation!
• Persons with electronic implants
(for instance, pacemakers) may not
remain in the same room in which
the ready-to-operate machine is
located.
• The warning signs provided (sym-
bol: "pacemaker") are to be placed
at the entrances to the room in
which the ready-to-operate machine
is located!
Burn hazard from hot parts!
• Wear protective clothing (protective
apron), safety shoes, safety gog-
gles and protective gloves.
• Always use mould tongs to move
moulds and hot crucibles.
• Touch hot crucible inserts and hot
cast metal with forceps only..
• Place hot parts only on a fireproof
surface.
• Danger of burns when draining the
cooling water!
• Carry out maintenance and clean-
ing work before casting or only after
the machine has cooled down.
Important!
• When laying cables and hoses, ensure that
they are protected from hot components (e.g.,
moulds)!
• Do not cover the ventilation slots located on the
left and the back of the machine!
• Never operate the device without supervision!
To Next Page
Loading...
Need help?
General
