English
⋅
Nautilus
®
CC plus
⋅
Nautilus
®
T
21
86066 BA-en/00 357.00001.../ 358.00001...
Insert both crucible halves.
(*) Uneven crucible tips that are not closed can be
smoothed by using fine emery paper (grain ≥ 80).
In the case of special alloys, sprinkle a pinch of
BEGO Auromelt HF melting powder on the alloy
(see program table on page 27).
Melting powder made by other manufacturers may
impair the casting result!
Comply with minimum and maximum quantities!
ATTENTION
(check before each casting
operation)
• The handles must lie on the base
surface.
• The crucible halves must close at
the bottom (*) and have a spacing of
1.5 to 3 mm at the top.
• Do not use damaged crucible
halves.
• Only CoCr / NiCr: do not use cruci-
ble halves with alloy residues on the
bottom.
Alloy residues can be easily removed if a drop of
water is added while they are hot.
To Next Page
Loading...
