Care and maintenance
Care
Fig. 1 Induction coil
If necessary, clean the machine on the outside with
a dry or slightly moist cloth.
Check the casting chamber daily for impurities
(casting pearls) and if necessary clean with cloth or
vacuum cleaner.
Do not use any abrasive materials as these could
damage the coating of the induction coil. The
coating reliably prevents short-circuits if there are
any impurities between the coil windings (casting
pearls).
The coating can wear away through regular use.
This is unavoidable and no cause for concern. The
operation of the machine is guaranteed regardless
of the condition of the coating.
Warning of electric shock!
Danger to life!
Switch off the machine and pull out
the mains plug before performing any
care or maintenance work.
(In the case of power connection
without mains plug: remove fuses,
secure machine so it cannot be
switched on again and check that it is
de-energized.)
Risk of burns due to hot parts!
Carry out maintenance and cleaning
work before casting or only after the
machine has cooled down.
To Next Page
Loading...
Need help?
General
