V7.4 Plus OP-L
Part 7: FAQ’s and Troubleshooting
My system stopped and an
error message reads:
1. Err1
2. Err2 & Err3
3. Err4
4. Err5
5. Err6
6. Err7
1. Thermostat is damaged or system
has been stored in sub 46F
environments*
2. Coffee beans have burned or the
oven chamber has experienced an
unacceptable rise in heat
3. Draw fan is damaged
4. DC fan is damaged
5. DC motor (roasting drum) is
blocked or damaged.
6. Denotes unattended safety feature
activated
If an error message appears, immediately
cease using the Behmor.
Then visit our website’s tech pages for
solutions and ways to contact tech support.
http://www.behmor.com/behmor-1600.php
Always check for Updates on our web site
*bring the unit into a warm environment to allow
sensors to warm & reset. This is a storage issue only
In cooling I noticed a little
smoke leakage.
We have worked to seal the door area
and other tiny cracks, but to
completely seal the system is
impossible. On rare occasions, wisps
of smoke may appear
We advise gently cleaning the door seal on a regular
basis with a damp cloth to ensure no chaff or other
particulate matter prevents a proper seal.
When roasting, I noticed a
little smoke from the
exhaust.
1. Occasionally, whether due to the
quality of the beans, the darkness
of the roast or the quantity of the
roast, small amounts of smoke
may be seen.
2. During the first couple of roasts
there may be a little smoke as the
system “seasons” itself.
3. Home wiring could be old and
doesn’t supply a sufficient amount
of voltage to run the system
properly.
1. Reduce the quantity of the types of bean that give
off smoke.
2. On subsequent roasts the smoke should go away.
3. Try different power outlet for a line carrying a
greater amount of voltage
Sometimes I notice, even
when I’ve added time I can’t
complete a roast to a desired
degree.
In some instances, depending on the
wiring in the home, there can be
voltage issues that are outside our
control.
In other instances sediment has been
allowed to build up and the interior
needs cleaning with Simple Green.
See “Section 6: Maintenance.”
1. Try using a different outlet. In some cases an
outlet only a few feet away can have better
voltage input and sustainability.
2. Try roasting at a different time of day. As is
true throughout the country during summer, the
afternoons are when the largest power
consumption occurs.
I tried the above and I still
have the same problem.
As stated above in some homes and
instances power being supplied by
your local power company could be an
issue and beyond our control.
Contact Tech Support via email and ask for Short
Weight details
While the chamber was still
warm I opened the front
door and noticed the gasket
is wavy in appearance.
The gasket is attached using tiny
nipples and not glued so the expansion
and contraction caused by heat up and
cool down has no ill effects on the
materials
When the roasting drum is
turning I hear squeaking.
Like any metal-on-metal rubbing,
noises can be emitted over time.
Take a Q-Tip, place a drop of food grade oil on it,
and rub the Q-Tip in the grooved area (round peg)
of the roasting drum
To Next Page
Loading...
