page 5 of 6
985-40000-01170 Rev.A
2021-02-02
Condential, for internal use only. Not to be reproduced.
page 5 of 6
Synthesizers and Samplers
CAT
OCTAVE Calibration (factory mode)
Set the Digital Voltmeter to measure a range below 10 VDC.
Locate the test points TP20 and GND on the bottom side. Set the position of the front panel OCTAVE SHIFT to -2.
Figure 3
Repeat steps 2 and 3 above until both notes are correct in the display. This may need to be repeated several times to
get right.
Turn o the VCO2 SAW fader.
This calibration is done after the oscillator calibration. The positions of knobs and switches are shown in red on
Figure 1.
To Next Page
Loading...
