25
E
5.4.1 Initial Settings For The Peak Limiter Section
lortnoC gnitteS
lortnocDLOHSERHTFFO
Tab. 5.3: Initial settings for the peak limiter section
The THRESHOLD control of the Peak Limiter sets the threshold level, so that subsequent units are protected
from overloading. If the LIM comes on regularly or is on constantly, the OUTPUT control of the Compressor
section must be turned down, as this control sets the level of the signal, which is routed to the Peak Limiter
section.
If this technique leads to an undesired drop in the overall level, it is recommended that you increase the
compression: either, reduce the threshold level, or increase the compression ratio with the RATIO control.
The OUTPUT control will compensate for a renewed drop in level.
5. APPLICATIONS
To Next Page
Loading...
Need help?
General
