Synthesizers and Samplers
CRAVE
page 4 of 6page 4 of 6
KB CV CALIBRATION
Button names and LEDs
In the user CV calibration mode, the buttons have new functions as shown in the tables below:
There are three test points A / B / C to be calibrated. Their target voltage is -5 V / 0 V / 5 V respectively.
Button Name Function
HOLD/REST Select test mode A
RESET/ACCENT Select test mode B
ARP/SETEND Select test mode C
PATTERN/BANK —
SHIFT —
PAGE —
PLAY/STOP —
REC Save
Button Name Function
STEP1 Select X1 (about ±1 mV)
STEP2 Select X2 (about ±4.5 mV)
STEP4 Select X3 (about ±9 mV)
STEP4 Select X4 (about ±45 mV)
STEP5 —
STEP6 —
STEP7 —
STEP8 —
KYBD Decrease
STEP Increase
To Next Page
Loading...
