10
EUROPOWER PMX660M/PMX880S
5. WIRING EXAMPLES
For stereo operation the POWER AMP switch of the
PMX880S must be set to its upper position (MAIN L/MAIN R).
Outputs A and B deliver the stereo main signal to the P.A.
speakers. Two active speakers, wired in parallel, are connected
to the PREAMP MONITOR output. They are used as on-stage
monitor speakers. The effects processors can be switched on
and off with a dual footswitch. This set-up is not possible with
the PMX660M (no stereo operation possible).
Fig. 5.1: EUROPOWER mixer as a stereo amplifier
(example)
5. WIRING EXAMPLES
Both the PMX880S and the PMX660M can be set-up for dual
mono operations. The POWER AMP switch must be set to its
lower (PMX660M) or center position (PMX880S). The two
SPEAKON
®
outputs provide the main and the monitor signals
independently of each other and to two loudspeakers each,
which are wired in parallel.
Fig. 5.2: EUROPOWER mixer as a dual mono amplifier
(example)
To Next Page
Loading...
