2 HELLBABE HB01
(5) The Q control allows to change the shape of the lter peak.
High Q settings (turned to right position) produce a large,
selective lter peak with a high output level. Low Q settings
(turned to left position) provide a lower output level
with a subtle, broad lter peak producing less vocal eect.
(6) Turning the FINE control allows to extend the toe-down
frequency of the sweep range up to 2.2 kHz.
(7) Use this ¼" TS IN connector to plug in the instrument cable.
(8) The ¼" TS OUT connector sends the eected signal to your amp.
(9) The ¼" TS OUT/BYPASS connector can be used as second output or
as bypass, hard wired to the input, to play out the uneected signal.
(10) The TIMER ADJ control (accessable through a hole in the housing)
is needed to adjust the time the eect remains active
after taking your foot from the pedal.
(11) Use the 9 V connection to plug in a 9 V power supply (not included).
(12) The STATUS-LED illuminates when the eect is activated.
(13) The BOOST-LED illuminates when the boost function is activated.
(14) The ROCKER SCREW allows to adjust the resistance
of the rocker mechanism.
The BATTERY COMPARTMENT is located at the bottom of the unit.
Open the lid to install or replace the 9 V battery.
◊ ◊ The HB01 has no on/o switch. As soon as you insert the jack
into the IN connector, the HB01 begins running. When not
using the HB01, remove the jack from the IN connector. This
extends the life of the battery.
The SERIAL NUMBER is located at the bottom of the unit.
Safety Instructions
Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualied servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.
Limited Warranty
For the applicable warranty terms and conditions and additional
information regarding Music Tribe’s Limited Warranty, please see
complete details online at musictribe.com/warranty.
To Next Page
Loading...
