Behringer LINK UCG102 - Installing the Guitar Combos Software

8 GUITAR LINK UCG102 Software Installation Guide
2.2 Installing the guitar combossoftware
The Guitar Combos software consists of three dierent combos.
Choose any or all of them for installation. Withthe serial number on
the CD sleeve you can fully activate one combo. Fordetails, refer to the
imprint on the CD sleeve. Allother combos can be run in demo mode
with the following restrictions:
• Saving of sounds is disabled
• Quits after 30 minutes
• Total recall is disabled
To install a combo on your system,
proceed as follows:
1) From the folder “NI Guitar Combos“ on your CD, choosethe
combo you wish to install and open the respective archive le
(ZIP) bydouble-clicking on itsentry.
2) Double-click on “Setup.exe“ to start the installation.
3) Follow the on-screen instructions.
If you have the serial number for the installed combo:
4) Accept to start the NI Service Center, by checking the
respectiveentry.
◊ If your computer is not connected to the internet, choose the
offline registration method to activate the combo via
another computer.