Behringer MicroPHONO PP400 - Setup Example

3
MICROPHONO PP400
•
• stereo, the other end of the audio cable must include a
¼", TRS connector
•
• mono, the other end of the audio cable must include 2 TS
connectors (one for each mono input)
SERIAL NUMBER: To register your unit, use the serial number that is
located on the bottom of the PP400.
Setup Example
The following is an example of how to set up the PP400:
Fig 2: PP400 setup example
OUTPUT
TAPE IN/STREREO
CHANNEL IN
TURNTABLE UB1204-PRO
MICROPHONO PP400
INPUT