Synthesizers and Samplers
NEUTRON
page 4 of 7page 4 of 7
In the Command Window, enter the SysEx command to be sent to the Neutron. For ASSIGN out calibration at 1 V,
the command is: F0 00 20 32 28 7F 10 20 F7
In the Command Window drop-down menu, select Send SysEx. The Sysex command will be sent to the Neutron.
Both 8' octave range LEDs will be ashing to indicate the Neutron is in ASSIGN out 1 V calibration mode.
Measure the voltage on the patch cable attached to the ASSIGN out and adjust until it reads 1 V +/- 0.001 V.
To Next Page
Loading...
