page 10 of 10
985-40000-01084 Rev.A
2021-02-03
Condential, for internal use only. Not to be reproduced.
page 10 of 10
Condential, for internal use only. Not to be reproduced.
Music Tribe accepts no liability for any loss which may be suered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.
Technical specications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik,
Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone and Coolaudio are trademarks or registered trademarks of Music Tribe Global
Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.
Synthesizers and Samplers
POLY D
Calibrate AFTER TOUCH Maximum Position
Apply pressure to any one of the keys (or multiple keys) until AFTER TOUCH value stops increasing (Region A LEDs will
indicate current AFTER TOUCH value).
Calibration Complete.
Press SHIFT + STEP to conrm and save all calibration results. Region B LED will show calibration results. Relative LED
will light to indicate corresponding channel is calibrated. Otherwise it may be a failed calibration.
NOTE: Press SHIFT + KYBD will cancel all calibration and return to normal mode.
TIPS:
A. You can calibrate only one of the channels (1-3) at a time.
B. For channel 4 and 5, you have to calibrate both of them simultaneously.
End of Procedure
To Previous Page
Loading...
Need help?
General
