Behringer PRO-1 - Modulation Routing; FIL ENV, OSC B, & LFO AMOUNT Knobs; FIL ENV, OSC B, & LFO ROUTE Switches; Destination Modulation Path Selection

Behringer Pro-1 Ctrlr panel documentation and instructions v2.0
sunny.synths@gmail.com Page 19 of 49
Depending on the state of Cables button in the Envelopes and Patches tab, either full cables (Cables
button ON) or cable plugs (Cables button OFF) will be displayed.
As soon as you are using the same input or the same output twice, the Cables button will be
locked ON and only full cables will be displayed.
All the patch cables are listed and can be further managed in the Envelopes and Patches tab.
It is always the next free cable that is selected automatically.
You delete an existing cable simply by re-drawing it from its output to its input.