ULTRA METAL UM300
Thank you for showing your confidence in us by purchasing the BEHRINGER ULTRA
METAL UM300. This high-quality effects pedal comes with a dual-gain circuitry that
enables you to produce super thick, tube-like distortion plus endless sustain. Thanks to
its high-performance features you will achieve the most extreme and sought-after hard
rock or heavy metal distortion sounds.
1. CONTROLS
Top view
The DIST(ortion) control adjusts the amount of distortion effect.
The HIGH control allows you to boost/cut the high-frequency range.
The LOW control allows you to boost/cut the low-frequency range.
Please keep in mind that extreme distortion and EQ settings will increase
noise and may induce oscillation.
The two MID FREQ(uency) controls allow to boost/cut a defined mid-frequency
range. The upper control is used to increase or lower the mid range, the control below
adjusts the center frequency of the mid range that is affected (200 Hz to 5 kHz).
The LEVEL control adjusts the output level.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connectionto plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
To Next Page
Need help?
Power
Power Supply Compatibility
Weight and Dimensions
