ULTRA OCTAVER UO300
3-Mode Octaver Eects Pedal
Thank you for showing your condence in us by purchasing the
Behringer ULTRA OCTAVER UO300. This high-quality eects pedal
creates a monster sound by adding two additional tones using your
guitar—one and two octaves below the original tone. Thanks to its
high-performance features you’ll get natural, clear octave sounds with
constant pitch, even for staccato playing.
Octave eect is possible due to a circuitry that generates signals one or
more octaves below the input signal.
1. Controls
(1) The RANGE selector allows you to optimize the eects pedal
for HIGH, MID and LOW frequencies and use instruments with
dierent frequency ranges (guitar, bass guitar, keyboard, etc.)
(2) The DIRECT control adjusts the level of the original input signal.
(3) The OCT 1 control adjusts the level of the generated signal one
octave below the original signal.
(4) The OCT 2 control adjusts the level of the generated signal two
octaves below the original signal.
(5) The blue ON/BATT LED illuminates when the eect is activated.
Italso serves as a battery level indicator.
(6) Use the footswitch to activate/deactivate the eect.
(7) Use this ¼" TS IN connector to plug in the instrument cable.
(8) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power
supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.
V1.0
(5)
(1)
(7)
(4)
(6)
(3)(2)
(8)
To Next Page
Need help?
General
